Table Top Display Cases
- Place Wood Base onto table surface
- Set Riser in place (in needed)
- Place your item centered on the base
- Place Glass Cover over item and inside the lips of the base
- Acrylic Holders Can be Found Within the Packaging
Wall Mounted Display Cases
Anchor Screw(s) into the wall so your frame can be level when hung. Make sure your anchors are strong enough to hold the weight of the display case and the item going inside.
Mount the frame on the wall, on to the anchored screw(s), just like you would a picture frame.
Once on the wall, remove the plastic wrap and foam sheet.
The lid (Top Panel of Glass) hinges up to gain access inside the dipslay case
Picture Frames
- Anchor Screw(s) into the wall so your frame can be level when hung.
- Fully Finished Frames are ready to hang
- For Frames that need photos or documents installs
- Pry up black framing points that go around the back of the frame
- Remove the Foam Board Backing
- If you have no matboard, insert photo/document over the glass and replace the foam board so it can be ready to hang
- If you have matboard, place your photo/document behind the matboard opening and tape it to the matboard in the corner. Then replace the foam board and it is ready to hang
Frameless Glass Photo Prints
- Remove the backing to the double sided, wall safe tape
- Place the glass print onto the wall
- Firmly press on the glass for a couple of seconds
- To reposition, pull from the bottom of the print to safely remove
- More Tape can be ordered here - https://www.perfectcases.com/double-sides-wall-safe-foam-tape/
Diploma Frames
- Pry up black framing points that go around the back of the frame
- Remove the Foam Board Backing
- Place your diploma behind the matboard opening and tape it to the matboard in the corner. Then replace the foam board and it is ready to hang
- Anchor Screw(s) into the wall so your frame can be level when hung.